(2 votes, average: 5 out of 5)
Loading ...Wed 14 May 2008
One of my customer’s recently started having problems receiving inbound calls although outbound calls worked just fine. Long story short, one of the dsp’s needed to be reset. When I issued the ’show voice dsp detailed’ command, the dspware version displayed all zero’s. After reseting the dsp, calls started working again.
To disable the dsp, use the following command in privileged exec mode.
router#test dsp device *pvdm slot* *dsp* remove
To re-enable the dsp, use the following command in privileged exec mode.
router#test dsp device *pvdm slot* *dsp* restore
To reset the dsp, use the following command in privileged exec mode.
router#test dsp device *pvdm slot* *dsp* reset
Other interesting dsp commands:
c2691#test voice driver
Enter VPM or HDV or ATM AIM or NM−HD−xx or HDV2 slot number : 1
HDV2 Debugging Section;
1 − FPGA Registers Read/Write
2 − TDM tests
3 − 5510 DSP test
4 − DSPRM test
5 − HDLC32 test
6 − Register location check
7 − Interrupt counters.
8 − Quit
c2691#test dsprm 1
Section:
1 − Query dsp resource and status
2 − Display voice port’s dsp channel status
3 − Print dsp data structure info
4 − Change dsprm test Flags
5 − Modify dsp−tdm connection
6 − Disable DSP Background Status Query
7 − Enable DSP Background Status Query
8 − Enable DSP control message history
9 − Disable DSP control message history
10 − show dsp version
11 − Show alarm stats
12 − Enable dsprm alarm monitor
13 − Disable dsprm alarm monitor
q − Quit
Related Sources:
DSP on NM-HDV2 Functionality Verification for 2600XM/2691/2800/3700/3800 Platforms
May 14th, 2008 at 7:18 am
Voice n00b question: What does “test dsp device print” do?
May 14th, 2008 at 7:32 am
In the video, I was trying to see if the disabled dsp would show up with the ‘test dsp device print’ command because it is not in the output of a ’show voice dsp’ command.
c2691#test dsp device ?
<0-3> Slot id - the module id on the system.
all all slots to be acted upon
print print DSPs not in “show voice dsp”