(20 votes, average: 4.55 out of 5)
Loading ...Sun 6 Apr 2008
GNS3 - How to build a frame-relay lab
Posted by Josh under Cisco , Cisco Routers , Dynamips , GNS3 -
In this tutorial, you will learn how to build a small frame-relay lab. I will walk you through adding the routers, the frame switch, configuring the PVCs on the switch, and configuring the routers for basic point-to-point connectivity.
This should give you a good basis for testing various QOS configurations, routing protocols as well as other frame-relay configs.
April 7th, 2008 at 7:55 am
Another fine job, Josh.
April 8th, 2008 at 8:42 am
Great job. It was really helped me to understand point-to-point frame relay. Do you think to make another video for multipoint frame relay ?
April 8th, 2008 at 6:00 pm
Nice job. Like the partial mesh used in the frame relay switch.
April 12th, 2008 at 2:42 am
well job supper
April 15th, 2008 at 4:00 am
Well Done! Thank you
April 15th, 2008 at 1:18 pm
@Taner, I doubt I will get to a multipoint frame-relay tutorial in the near future. I have other things I would like to demonstrate more. You should be able to take the principles learned in this tutorial to build a partial mesh or full mesh.
@Everyone Else, Than you and you are welcome.
Josh
May 22nd, 2008 at 1:48 pm
Good example to make small lab fot FR!
—
Andrey
May 22nd, 2008 at 8:42 pm
@Josh, Your tutorial was great indeed.. thank you for sharing this… by the way can you help me figuring out my problem with my GNS3..
I follow the instruction in your tutorial, it was amazing.. though after configuring the routers then saving my topology.. when I exit the GNS3 then re-open it again.. all the configuration I made to the router was erased… is this the behaviour of the application?
Thank you in advance…
June 3rd, 2008 at 12:47 pm
good job! its very useful…
June 4th, 2008 at 7:29 pm
Great, fantastic, excellent and I’m deeply indebted.
Wasnik, you have to issue the write command or the copy running-config startup-config to keep the router configuration from session to session, just like a real router.
June 5th, 2008 at 4:32 am
[...] These labs were built based on BlindHogs’ How To build A Frame Relay Lab [...]
June 17th, 2008 at 8:12 pm
[...] These labs were built based on BlindHogs’ How To build A Frame Relay Lab [...]
June 18th, 2008 at 3:12 am
http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml
Here you will find some labs using the same topology that helped me to understand IARP,p2p and multipoint interfaces behaviour.
June 29th, 2008 at 11:03 pm
Thanks alot mate
You are a star
July 16th, 2008 at 1:38 pm
I need to know how to configure the ATM switch.
July 19th, 2008 at 6:20 am
I am configuting point to multi point but its not working.
July 19th, 2008 at 9:10 am
Nice
Thanks for this tutorial - that was exactly what I’ve been looking for.
Kind regards from Germany…